2.3 Installing the second projector (Set B)
Deciding installation position
Decide the position of Set B and its projection angle.
→
Arrangement
WARNING ►Only for
to install the projector for any direction with specified mounting accessories.
Consult with your dealer about such a special installation.
• Set the tilt angle of Set B to within 9 degrees from the level line.
NOTE
Connecting projectors
To use Intellectual Stack, connect an RS-232C cross cable between the
CONTROL port of Set A and Set B.
Setting up Set B
1.
Turn on Set B.
• After turning on Set B, make sure the image of Set B is not
NOTE
significantly tilted compared to the image of Set A. If the image is overly
tilted, rotate the elevator feet of Set B to adjust the angle such that the tilt is
just about right.
2.
Reset the adjustment of KEYSTONE and PERFECT FIT on Set B.
(Operating Guide
• KEYSTONE cannot be operated when PERFECT FIT is in use. To
NOTE
reset both functions, reset PERFECT FIT first.
• Perform the INSTALLATION setting first if necessary as it may change the
image position.
(continued on next page)
and
Adjusting the projector's
,
→
EASY MENU
(Operating Guide
(User's Manual (concise)
elevator)
and
, it is possible
or
SETUP
menu)
→
SETUP
menu)
8
Installation