Philips NORELCO S331 Series Manual page 12

12
English
Charging with the power cord
2
1
Charging with charging stand (S3311 only)
Charge the shaver before you use it for the first
time and when the display indicates that the
battery is almost empty.
Charging takes approx. 1 hour. A fully charged
shaver has a shaving time of up to 60 minutes.
This shaver is suitable for use in the bath or
shower. For safety reasons, it is therefore
not possible to use the shaver while it is
connected to the power outlet for charging.
Note: Depending on your shaving/styling
behavior and beard type, the operating time
may vary over time.
1 Make sure the product is turned off.
2 Put the small plug in the product (1) and
connect the power plug into any 100V to
240V AC outlet (2).
- Use only the power cord provided.
- The display on the product will indicate the
product is charging.
3 After charging, remove the power plug from
the wall outlet and pull the small plug out of
the product.
1 Connect the small plug of the cord into the
charging stand. Connect the supply unit into
any 100V to 240V outlet. Use only the
power cord provided.