Smeg CSE68X3 Instruction Manual page 13

CHANGING A PROGRAM
To change the running program it is necessary:
•
to interrupt the running program (see "I
•
select the new program;
• start the program (see "S
ANNULLING A PROGRAM
To annul the program, keep the START/PAUSE button (2) pressed until
the program is interrupted (light on and confirmation beep).
Press button (2) again and keep it
pressed until the lights 4 and 5 (marked
"end") come on.
The water in the tank will be pumped out and the program will end at the
point where it was interrupted.
In case that the door is opened during the operation, to the next door
closing it is going to be necessary to start the program as shown in
paragraph "
point in which it was interrupted.
In case that the tub temperature is higher than 50°C the program
will start about 30 seconds later.
14
User instructions
5
1
TARTING THE PROGRAM
". The program will resume from the
S
TARTING THE PROGRAM
4
3 2
");
NTERRUPTION A PROGRAM
").