Bosch Professional GLF 18V-8 Instructions Manual page 8

8 | English
Please observe the illustrations at the beginning of this oper-
ating manual.
Intended use
The power tool is intended for copy routing as well as routing
grooves, edges, profiles and elongated holes in wood,
plastic and light building materials while resting firmly on the
workpiece.
Product features
The numbering of the product features refers to the diagram
of the power tool on the graphics page.
(1) Drive unit
(2) Routing base
(3) Knurled screw for routing base
(4) Knurled screw for parallel guide/pilot
a)
(5) Router bit
(6) Cap nut with collet
(7) Collet
(8) Spindle lock button
(9) Guide plate
(10) Base plate
(11) Dust extraction adapter
(12) Wing bolt for routing base
(13) On/off switch
a)
(14) Rechargeable battery
a)
(15) Battery release button
(16) Speed preselection thumbwheel
(17) Handle (insulated gripping surface)
(18) Worklight
(19) Scale for setting the routing depth
(20) Tool holder
(21) Open-ended spanner (13 mm, 17 mm)
a)
(22) Guide bushing
(23) Parallel guide
(24) Wing bolt for parallel guide
a)
(25) Guide
(26) Wing bolt for fixing the horizontal alignment
(27) Wing bolt for horizontal alignment of the guide
a)
(28) Guide roller
a)
(29) Dust extraction adapter
a)
(30) Extraction hose
a) Accessories shown or described are not included with the
product as standard. You can find the complete selection of
accessories in our accessories range.
Technical data
Edge router
Article number
1 609 92A 91T | (22.02.2024)
Edge router
Rated voltage
Rated no-load speed
Speed preselection
Constant electronic control
Connection for dust extraction
Compatible collets
B)
Weight
Recommended ambient tem-
perature during charging
Permitted ambient temperature
during operation
storage
Recommended rechargeable
batteries
Recommended battery chargers
A) Measured at 20–25 °C with rechargeable battery ProCORE18V
4.0Ah
B) Depends on battery in use
C) Limited performance at temperatures < 0 °C
Values can vary depending on the product, scope of application and
environmental conditions. To find out more, visit
www.bosch-professional.com/wac.
Rechargeable battery
Bosch sells some cordless power tools without a re-
chargeable battery. You can tell whether a rechargeable bat-
tery is included with the power tool by looking at the pack-
aging.
Charging the battery
Use only the chargers listed in the technical data. Only
u
these chargers are matched to the lithium-ion battery of
your power tool.
Note: Lithium-ion rechargeable batteries are supplied par-
tially charged according to international transport regula-
tions. To ensure full rechargeable battery capacity, fully
a)
charge the rechargeable battery before using your tool for
the first time.
a)
Inserting the Battery
Push the charged battery into the battery holder until it
clicks into place.
Removing the Battery
Note: Only remove the battery when the power tool is
switched off.
To remove the rechargeable battery, press the battery re-
GLF 18V-8
lease button and pull the battery out. Do not use force to do
3 601 FC6 0..
this.
GLF 18V-8
V
A) –1
min 10000–30000
mm
inches
kg
°C
°C –20 ... +50
C)
and during
GBA 18V...
ProCORE18V...
Bosch Power Tools
18
●
●
●
6/8
1/4"
1.5–2.5
0 to +35
GAL 18...
GAX 18...
GAL 36...