Installation - Pioneer DC-110Z Operating Instructions Manual

ANTENNA INSTALLATION
Notes concerning the antenna terminals:
e The PAL connector is provided only on tuners with LW reception.
® Depending on the model, antenna terminals differ as shown
below:
AM LOOP ANTENNA INSTALLATION
The AM loop antenna is supplied with the stereo tuner. Connect the AM loop
antenna to the AM antenna terminais.
TX-1102/TX-11142Z/TX-110ZL/TX-141Z2L TX-2202/TX-2212Z/TX-220ZL/TX-2214ZL
NOTE:
¢ Do not install the AM loop antenna in a location where it may come in
contact with any metal objects.
* Keep the AM loop antenna connected even after an AM outdoor anten-
na has been erected.
FM) raAM4
jolo|@Jelo Ola)
AM LOOP ANTENNA
e Unfold all four legs of the AM loop antenna toward the outside, and insert
the stopper inside the legs into the hole in the AM loop antenna to fix it in
® Set the antenna on a level surface, and point in the direction that gives op-
¢ Do not install the antenna in locations where it touches the metal objects, or
near a CD player, personal computer, or television set.
e Connect the power cord of the cassette tape deck amplifier to the audio timer
(See page 2).
@ Operation may vary depending on the audio timer; be sure
to consult the operating instructions for the audio timer.
Leg
Stopper
UNATTENDED RECORDING
AM OUTDOOR ANTENNA | 1. Set the POWER switch to ON.
In areas with strong radio waves, the accessory AM loop antenna will be suffi- 2. Load a non-recorded (blank) tape.
cient for radio reception. In the event that nearby buildings or objects make 3. Push the FUNCTION switch in the TUNER position on the cassette deck
reception difficult, or when distance from broadcasting stations results in weak amplifier and operate the tuner to tune in the station whose program is to be
radio waves, an outdoor AM antenna should be installed. recorded.
. | 4, Set the time on the audio timer so that the power comes on at the desired
T-TYPE FM ANTENNA INSTALLATION time (this action switches off the power to the cassette deck amplifier).
5. Push the REC switch.
The T-type FM antenna is supplied with the stereo tuner. This should be used as
6. At the preset time, the power will be switched on and recording will start
a stopgap antenna until an outdoor FM antenna is erected.
1. Connect the two leads of the T-type FM antenna to the terminals marked automatically.
BAL 300 ohms on the tuner's rear panel. | ,
2. Spread the two ends of the T-type FM antenna horizontally and secure the WAKE-UP PLAYBACK
antenna to @ wall, etc. i. Set the POWER switch to ON.
. 2. load a pre-recorded cassette tape.
EXTERNAL FM ANTENNA INSTALLATION 3. Push the FUNCTION switch in the TAPE position on the cassette deck
Use an external antenna when the signals from the station are weak and cannot amplifier and adjust the VOLUME control to the appropriate level.
be picked up by the accessory T-type FM antenna, or when the sound heard is 4, Set the time on the audio timer so that the power comes on at the desired
accompanied by large amounts of noise. There are two ways of connecting the time (this action switches off the power to the cassette deck amplifier).
external FM antenna to the ANTENNA terminals: with 300-ohm feeder wire, or 5. Push the PLAY switch. At the preset time, the power will be switched on
with a 75-ohm coaxial cable. and the Beypaen will start automatically.
It is recommended that you use the 75-ohm coaxial cable so that the effects of
extraneous noise are reduced to a minimum.
S PE Cc FI re TI O N S
When the connecting cable When the connecting cable is 7
is 75-ohm coaxial cable a 300-ohm feeder wire
75-chm coaxial cable
without PAL connector
AM PLIFIER SECTION
Continuous Average Power Output is 25 Watts* per channel,
min., at 8 ohms from 40 Hertz to 20,000 Hertz, with no more
than 0.3% total harmonic distortion.
*Measured pursuant to the Federal Trade Commission's Trade Regulation
75-ohm coaxial cable — rules on Power Output Claims for Amplifiers.
with PAL connector
Continuous Power Output
AOD to 20,000HZ .......c.ceceseccerescevere ees 25W + 25W (T.H.D. 0.3% 8 ohms)
TKAZA DIN): sutuctassaswoses sousesanent iauehea cs 32W + 32W (T.H.D. 1% 8 ohms}
1 kHz (DIN music power) .........csesereeces 45 W + 45 W (T.H.D. 1% 8 ohms)
Hum and Noise (IHF, short-circuited, A network)
PRONG © cackiaccaciuniesederunicawdolsioun venus cdarredidacecdudeewsiens MeneeetUeaees ite 72 dB
Hum and Noise (DIN continuous Power/50 mV)
PHONG > cerscvccctesicccrasanteerkeitacbesacadneanceanbiepinacreteaaekuencese 68 dB/60 dB
Total Harmonic Distortion (40 Hz to 20,000 Hz, 8 ohms), from CD/VIDEO
12.5 Watts per channel power OUtpUt ............0ceeene eens . No more than 0.2%