Advertisement
■ OPERATION
© Once you have all cords connected, the knobs
on the panel should be set as shown in the
illustration.
* Always make sure you turn down the volume
on
your
amplifier
before
connecting
or
disconnecting any cords.
0
Depress the pedal switch 0 to turn the effect
on.
(The Check Indicator will light up.)
0
Use the Sens knob 0 to adjust the sensitivity
so it is appropriate for the signal that is to be
input.
@ Using
the
Frequency
knob
0
select the
frequency
band
over
which
the enhancer
effect will be applied.
* The enhancer effect is normally perceived as
being
more prominent when the frequency
band is set in the lower ranges.
■ BATTERY REPLACEMENT
(©Loosen the thumb screw on the pedal
to open it.
©Take out the battery from the battery
housing
and disconnect the battery
snap.
©Connect a new battery to the battery
snap,then replace the battery in to the
battery housing.
* Make sure that the polarity of the
battery is correct.
(©Push the coil spring into the spring
base on the rear of the pedal,then
close the pedal.
* Make sure that the snap cord is not
caught in the pedal or coil spring.
©Insert the thumb screw into the guide
bush
hole
and
firmly
tighten
the
screw.
Use one 9-volt battery
Use the Mix knob 0 to determine the respec¬
tive percentages of original input signal versus
effected signal which will be contained in the
mix.
■ IMPORTANT NOTES
•Do not subject the unit to temperature
extremes (eg.
direct sunlight in an
enclosed
vehicle).
Avoid
using
or
storing the unit in dusty or humid
areas or areas that are subject to high
vibration levels.
• Remove the battery whenever the unit
is
not
going
to
be used for' an
extended period of time.
• When operating solely on a battery,
the
unit's
indicator
becomes
dim
when the battery is depleted. Replace
the battery immediately.
• If there is a battery in the unit while
an AC adaptor is being used, normal
operation will continue should the line
voltage be interrupted (power black¬
out) or the power cord become dis¬
connected.
• Should a malfunction occur (or if you
suspect
there
is
a
problem)
dis¬
continue
use
immediately.
Contact
• SAMPLE SETTINGS
Rhythm setting
Lead setting
qualified service personnel as soon as
possible.
• OUT: 9VDC/200mA
Advertisement
