Table of Contents
Advertisement
Basic Operation
Unit Installation
WARNING
See the section "Installation Warnings". (P.5)
Single DIN Opening Installation
This section explains the installation if your
vehicle has a single DIN opening (2" x 7").
1.
Remove the trim plate from the front panel.
Use a screwdriver to pry open the trim plate.
2.
Remove the mounting sleeve from the unit.
Insert the two supplied release keys into the
locking tabs on both sides of the unit, then
pull the mounting sleeve off.
Then secure the mounting sleeve into
the dash opening. Bend the tabs on the
mounting sleeve to lock the sleeve into place.
3.
Insert the unit into the dash opening/
mounting sleeve.
4.
Secure the supplied metal strap to the rear of
the unit to provide extra fastening (if your car
does not have a rear bracket to fix the unit).
Use the supplied hex bolt, hex nut (a), spring
washer (b), plain washer (c), tapping screw to
fix the metal strap.
Replace the trim plate after the installation.
8
Before you mount the unit into the dash, complete the wiring connection (P. 28 to 33).
Dash board
Metal strap
a b c
Single DIN opening
Mounting sleeve
* I
f your car has a rear bracket to fix the unit's rear, no
need to install the metal strap. Use the supplied hex
bolt and rubber grommet to secure the unit's rear
through the hole of the rear bracket.
The supplied hex bolt
and rubber grommet
Car's rear bracket
Unit secured with the
car's rear bracket
Unit secured with the
metal strap
*
Hex bolt
Release key
Bend the tabs
Trim plate
Advertisement
Table of Contents
