Table of Contents
Advertisement
In case of difficulty
If your controller does not operate as expected, the cause may be some error in system connections or control settings. Con-
sult the table below to see if the problem can be corrected.
If trouble persists, consult your dealer or service representative.
During video operation
Cause
Remedy
nected.
TV programs cannot be received.
The antenna cable disconnected.
Connect the antenna cable firmly.
The video tape being played back and the
The TV program selector not set to the va-
Set the TV program selector to the vacant
TV program are mixed.
cant channel.
channel 3 or 4.
When the video deck is played back, the
The MODE switches on the rear panel of
Set the switches to MONO.
sound is output from the left or right
this unit set to STEREO.
speaker.
Stereo source signals are reproduced in
The MODE switches set to MONO.
Set the switches to STEREO.
mono.
When the SELECTOR switch setting of this
The vertical or horizontal hold adjustment of | Adjust the vertical or horizontal hold control
unit is changed, the picture on the TV
the picture not properly set.
of the TV set to make the picture stable.
screen becomes unstable.
When audio dubbing is done to a video tape
'The input selector switch of VIDEO
1 or 2
Set the input selector switch to LINE (AUX),
on VIDEO 1 or 2, unexpected signals are re-
set to TV (TUNER).
corded on the tape.
SL
ere
preven
During audio operation
Cause
Remedy
—_———_—$—$—$—$———
eee
Sound audible but continuous background
TV signal picked up by turntable output
Route turntable cord so that hum is mini-
buzz interferes.
cord. Frequently occurs near TV transmit-
mized.
ting antenna.
Howling noise occurs when volume is
Speaker vibrations induce feedback in pick-
Increase distance between turntable and
raised or bass response is increased.
up.
speakers. Choose speaker locations care-
fully.
——
re
10
Kvc-475(uU)
i
i]
i
:
i
;
Advertisement
Table of Contents
