Heathkit SG-8 Assembly And Operation Manual page 14

(/) Connect the other wire to TB2 (NS).
(vy Connect the free end of the wire coming from TA3 (see Pictorial 2) to M3(S). Run wire as
shown in Pictorial 3.
«4 Connect a bare wire to N2 (S). Cover wire with a 2 1/2" length of spaghetti. Run wire
through grommet P and connect to the center terminal of the RF OUT connection (S). See
Pictorial 4,
() Connect a short bare wire from the lug on the RF OUT connector (S) to the pilot light ter-
minal nearest the panel (S).
Ghbaiten the free end of the yellow transformer wire to the rear pilot light terminal (NS).
f-) Connect a short bare wire from Gi (S) to K12 (S).
(4 Connect a 5600 & resistor from G5 (S) to TD1 (S).
() Connect a .01 fd ceramic condenser from G6 (S) to K2 (S). (Use sleeving. )
(/) Connect a 390 KQ resistor from K8 (NS) to K10 (S).
Page 13