Heathkit SG-8 Assembly And Operation Manual page 10

{ .} Connect a bare wire from BR3 (S) to C3 (S).
(Vv) Connect a bare wire from BR4 (S} to D8 (S).
(/) Connect coil E3 from BF6 (S) to BRS (S).
This completes the sub-chassis wiring.
ASSEMBLY OF CHASSIS
a
oO
8
eo Jed
r)
1 B20 ae?
@(ee 65)
NOTE:
Refer to Figure 6.
Figure 6
asa Install 3/8 rubber grommets in holes A, C, D, E, F and P.
(4 Mount a 7-pin miniature socket in hole G, using 3-48 screws and nuts. Position as shown
in Figure 6.
/) Mount the selenium rectifier with the side having the plus or cathode marking facing out-
ward from the back of the chassis. Use a 1" 6-32 screw through the dimpled hole in the
rear apron of the chassis. Fasten with a lockwasher and nut. Position as shown in Figure
6.
Page 9