Advertisement
Refrigerator Compartment
A. Internal light (depending on the model)
B. Shelves
C. LED lights (depending on the model)
D. Lid for the Meat & Fish box (if included)
E. Meat & Fish box (if included)
F. Crisper drawer lid
G. Crisper drawers
H. Rating plate (at the side of crisper drawer)
I. Control panel
O. Dairy drawer
P . Door trays
Q. Bottle holder (if provided)
R. Bottle bin
Least cold zone
Intermediate temperature zone
Coldest zone
Crisper zone
Freezer Compartment
L. Upper basket (freezing zone)
M. Middle and lower baskets (storage area for frozen and
deep-frozen food)
N. Ice cube tray (if provided)
Note: All shelves, door trays and racks are removable.
The right temperatures for the storage of foodstuffs are
preset in the factory.
Read the user handbook carefully before using the
appliance.
Specifications, technical data and images may vary
from model to model.
QUICK START GUIDE
Freezer compartment temperature
A different temperature can be set using the "FREEZER" button.
Fast Freezing
To be activated several hours before large quantities of food to be
frozen are placed in the freezer compartment. Press the "FREEZER"
button repeatedly until "FF" appears on the display.
The function disables automatically after 48 hours or can be switched
off manually by pressing the button again.
On / Stand-by
Press and hold for three seconds to enable/disable the appliance.
The lamp lights up in stand-by mode.
Notes: This operation will not disconnect the appliance from the power
supply.
What to do if...
The control panel is off and the appliance is not working.
There may be a problem with the power supply to the appliance.
Only for models fitted with two displays: The control panel
remains lit up (even when the door is closed), the internal light
Refrigerator door open alarm.
is not working (or blinks) and an acoustic signal sounds (if not
This activates when the refrigerator door is left open at length.
previously disabled).
If the control panel is fitted with 2 displays, check that it is not a refrigerator door open alarm (see previous line).
The internal light is not working.
In all other cases, you may need to replace the light.
It is not cold enough inside the compartments.
There could be various causes (see "Solutions" column).
Water collects at the bottom of the refrigerator compartment. The defrost water drain is locked.
The front edge of the appliance near where the door seal
This is not a defect. It is a design feature to prevent condensation from forming.
strikes is warm.
The control panel won't do anything: every time a key is pressed,
The "Key Lock"
"CL" or "LO" appear on the display.
Freezer compartment temperature alarm
The temperature alarm indicates that the temperature in the compartment is not ideal. This can happen: When it is first
The red indicator lamp will light up
and a beep will sound
used after defrosting and/or cleaning, when freezing large quantities of food or when the freezer door doesn't close
(if not previously disabled).
properly.
Malfunction Alarm
The red indicator lamp
is flashing, there are letters on
The alarm indicates that a technical component has malfunctioned.
the display, and a buzzer is sounding (if not previously disabled).
Blackout Alarm (where provided)
A buzzer sounds, and the freezer temperature display and the
This alarm activates when there has been an extended power failure causing the freezer compartment temperature to
red indicator lamp
(if installed) flash.
rise. The value flashing on the freezer display is the highest temperature reached during the power failure.
Antibacterial filter exhausted (if installed).
A buzzer sounds. The red indicator lamp
flashes or the
Replace the antibacterial filter.
letters "AF" appear on the display (depending on the model).
D
GB
F
NL
E
P
I
GR
S
N
The display can show either the temperature in the refrigerator compartment (from
2°C to 8° C) or the temperature in the freezer compartment (between -17°C and -
24°C). When "FF" is shown on the display, the "Fast Freezing" function is enabled.
Possible causes
function has been enabled.
DK
FIN
Refrigerator compartment temperature
A different temperature can be set using the "REFRIGERATOR" button.
Vacation Function
This function can be used during extended absences. Press and hold the
button
for 3 seconds to enable/disable the function. The display
will show the refrigerator compartment temperature (+12°C). On
activating the function, remove all perishable food from the refrigerator
compartment and keep both doors closed: the refrigerator will maintain
the right temperature to prevent odours from forming. The freezer
remains enabled.
Switching off acoustic alarms
To switch off acoustic alarms, press the "Reset Alarm" button.
Key Lock
The key lock can be enabled/disabled by pressing and holding the "Reset
Temperature or
Alarm" key for three seconds until a beep sounds to confirm your
Malfunction Alarm
selection: "LO" appears on the display for a few seconds. A beep will
See table below.
sound and "LO" will appear on the display for a few seconds if a key is
pressed while the key lock is enabled.
Solutions
Check:
· If there has been a power failure.
· If the plug is inserted properly into the power socket and the bipolar mains switch is in the right position (i.e. power
supplied to the appliance).
· Safety protection devices in the domestic electrical system are working.
· The power cable isn't broken.
To switch off the acoustic alarm, press the mute alarm button and to remove an alarm completely, close the refrigerator
door. On re-opening the door, check the light is working properly.
Models with standard lights: unplug the appliance from the mains power supply, check the bulb and replace it if necessary
with a new one (see section entitled "Maintenance and Cleaning Appliance").
Models with LED lights: contact an authorized After-Sales Service.
Check:
· The doors close properly.
· The appliance is not near a heat source.
· The right temperature has been set.
· the circulation of air through the fan grilles at the bottom of the appliance is not obstructed (see section entitled
"Maintenance and Cleaning Appliance")
Clean the defrost water drain hole (see section entitled "Maintenance and Cleaning Appliance").
No action is required.
Disable the
"Key Lock" function as explained in the Quick Start Guide.
Press the "Acoustic alarm mute" button to switch off the acoustic signal. The red LED goes off automatically when an
optimal temperature has been reached. If the temperature alarm persists, contact an authorized After-Sales Service.
Call an authorized After-Sales Service. Press the "Acoustic alarm mute" button to switch off the acoustic signal.
Press the mute alarm button to switch off the acoustic signal. Check the state of foodstuffs before consuming them.
After replacing the filter, press and hold the mute alarm button for at least three seconds: the red indicator lamp
will go off.
GB
5019 608 01074
Advertisement
