View And Record Video - Axis M4216-V User Manual

AXIS M4216-V Dome Camera
Configure your device
Record and watch video
Record video directly from the camera
1. Go to Video > Image.
2. To start a recording, click
If you haven't set up any storage, click
network storage on page 11
3. To stop recording, click
Watch video
1. Go to Recordings.
2. Click

View and record video

This section includes instructions about configuring your device. To learn more about how streaming and storage works, go to
Streaming and storage on page 54.
Reduce bandwidth and storage
Important
Reducing the bandwidth can lead to loss of detail in the image.
1. Go to Video > Stream.
2. Click
3. Select Video format H.264.
4. Go to Video > Stream > General and increase Compression.
5. Go to Video > Stream > Zipstream and do one or more of the following:
Note
The Zipstream settings are used for both H.264 and H.265.
- Select the Zipstream Strength that you want to use.
- Turn on Optimize for storage. This can only be used if the video management software supports B-frames.
- Turn on Dynamic FPS.
- Turn on Dynamic GOP and set a high Upper limit GOP length value.
Note
Most web browsers don't support H.265 decoding and because of this the device doesn't support it in its web interface.
Instead you can use a video management system or application that supports H.265 decoding.
.
again.
for your recording in the list.
in the live view.
and . For instructions on how to set up network storage, see Set up
10