Other Play Methods - Panasonic SL-S200 Operating Instructions Manual

Other Play Methods
The letters such as @ in the various illustrations refer to the descriptions in the "Location of Controls" section (see page 2).
Skip play
The аіѕс plays from the specific track through to the
end, then play stops automatically.
Preparation: Put unit in stop mode.
1
NORMAND
@ gion ч тр"
2 Select the desired track.
SKIP = SEARCH
О | «| |
a,
Lie -*
©
сз
Random play
1 NORMAL
@ RESUME 11 ЕВАМООМ:
Со рш)
—
N
©
[Release]
NORMAL
@ RESUME 0 i i RANDOM
{90 {00
—
For your reference:
elt is also possible to press the рч button while the
unit is in stop status to change the first track to be
played. {All tracks are played eventually, regardless of
which is played first.)
Program play is not possible in the random made.
Resume play
This function allows you to listen from the beginning of
the track where play stopped because the unit was
powered off (or switched to stop status}. It is useful
when listening to CDs in the car, etc.
NORMAL
RESUME + è 1 RANDOM
© 'Ginn
NORAD
@ RESUME 171 1 RANDOM
Loo Loof)
————ф»
For your reference:
elf the RESUME, NORMAL, RANDOM (play mode)
slider is put in the RESUME position, the all-
repeat function will be activated automatically as soon
as the unit is powered on.
elf power is cut off near the end of a track (power off
Status), playback may resume from the beginning of
the next track.
elf the unit is powered off while a disc was playing and
then a new disc is inserted, play will begin from the
middie of the new disc because the unit remembers
the position where play stopped on the old disc.
Program play
Up to 24 tracks can be entered in the programmed se-
quence.
Preparation: Put unit in stop mode.
tNORMAD
@ RESUME 1 1 1 RANDOM
2 Select the desired track.
" = SNP = SEARCH
-0 GLEAN
Б. КА
З Register іп sequence.
The indication "М" and the programmed se-
quence appear on the display panel.)
MEMORY/
Ө уи
4 Repeat steps 2 and 3 to program all
the desired tracks.
©
ШЕ To program the same track in the se-
quence more than once
After step 3, press MEMORY/RECALL the desired
number ої times.
@if"f"isdisplayed ,
No more tracks can be programmed.
Ш To confirm the contents of the program
Press MEMORY/RECALL while the disc is playing.
(The number of the programmed tracks appear on
the display panel in sequence.)
@ To delete the entire programmed se-
quence
Press 8, POWER OFF. .
Repeat function
Press REPEAT while disc is playing ог when unit is іп
stop status.
REPEAT
For your reference: |
If REPEAT is pressed during program play, 'only the
tracks in the program are repeated. |
(The indication "ALL" is пої displayed.)
The setting is switched in the sequence indicated below
each time REPEAT is pressed.
1-track repeat (1 œ>)
= track is repeated.
All-track repeat {ALL œ>)
& the tracks on the disc are repeated.
Cancel
Changing the sound quality
XBS ON:
Select this setting to boost the low-range response.
XBS
'ONT (OFF
©
—.
OFF:
Select this setting to turn off the XBS function.
OND CEE
© сш
This function is not available when using the OUT jack.