Sony TRINITRON KV-32S12 Service Manual page 19

(2) KV-32TW67/32TW68
@Four nuts
(Picture tube
special nut)
®Bezel assy
@Anode cap
®Deflection yoke
@Picture tube
@Seven screws
(+PW 4X30)
@Four claws dh
QA
@Two screws
(+P tapping screw)
@Glass door assy
¢ REMOVAL OF ANODE-CAP
NOTE: Short circuit the anode of the picture tube and the anode
cap to the metal chassis. CRT chield or carbon painted on
the CRT, after removing the anode.
"REMOVING PROCEDURES "HOW TO HANDLE AN ANODE-CAP
@ Don't hurt the surface of anode-caps with
sharp shaped material!
@ Don't press the rubber hardly not to hurt
inside of anode-caps! A material fitting
called as shatter-hook terminal Is built in
the rubber.
@ Don't turn the foot of rubber over hardly!
The shatter-hook terminal will stick out or
@ Turn up one side of the rubber cap in the hurt the rubber.
direction indicated by the arrow @.
® Using a thumb pull up the rubber cap firmly
in the direction indicated by the arrow ®.
Anode button
@ When cne side of the rubber cap is sepa-
rated from the anode button, the anode-
cap can be romoved by turning up the rub-
ber cap and pulling up it in the direction of
the arrow ©.