DeWalt DXCM009-0370 Instruction Manual page 16

Note: When using a shop vacuum, clean the filter periodically
to maintain adequate suction and effectiveness of the vacuum.
Read and understand shop vacuum owners manual.
Insert your hands into the gloves. Be certain your fingers are
properly positioned and you can move your hands easily and
grip the workpiece comfortably.
Depress foot control pedal to operate the gun. Hold the work
piece, and position your fingers so that the glove is not in the
way of the workpiece. Reposition the workpiece as needed in
order to access the complete surface area.
Use a circular motion or side-to-side motion. The nozzle
should be approximately 2 inches away from the work piece.
This unit is equipped with a cabinet abrasive media vibrator.
If abrasive media is not funneling to the bottom of the cabinet
to the pickup tube, adjust vibrator by turning the control knob
counter clockwise for increased vibration and clockwise for
reduced vibration.
Blast Cabinet Vent: Adjust cabinet vent to change pressure in
cabinet. Opening vent will decrease cabinet pressure and clos-
ing the vent will increase cabinet pressure.
Once the workpiece is completed, remove your hands
from the gloves & turn the blast cabinet and shop vacuum
off.
See maintenance and cleaning section when the job is
completed.
16