Table of Contents
Advertisement
9. Switch your TV to all other tuned channels, including that tuned for your video, and check
the picture quality. If there is no interference, go to chapter 6.
If there is any interference, continue as follows:
-
Disconnect your aerial from the back of the receiver.
-
Make sure that your TV is on the channel you have tuned for watching digital
programmes
-
If you have the welcome message on-screen, press the SELECT button on your
remote. You will now see the main menu screen.
-
From the main menu, select option 4 viewing preferences, option 2 tv and video
settings and then option 6 uhf channel number.
The current setting for this option is 38, which needs to be changed if you are
experiencing interference. To do this, use the number buttons to enter a new uhf
channel number. Choose one that is significantly different from 38. Press the RED
button (back) to move back a screen and store your setting.
-
Repeat previous steps from step 6 Tuning your television to see if the picture
improves. When you are satisfied with the picture, continue to chapter 6.
4.3 CONNECTING TO YOUR HIFI
Please refer to your HIFI's instruction book should you require further information.
4.4 INSERTING YOUR SMARTCARD
In order to watch ONdigital channels your viewing smartcard needs to be inserted in the
smartcard slot on the front of your digital receiver.
Remove the smartcard from the ONdigital envelope supplied with your receiver and insert into
the smartcard slot on the front of the receiver. You should have the ARROW facing forwards into
the box and the GOLD CHIP facing upwards. Push the card into the slot as far as it will go, the
end will be visible outside of the slot.
DIGITAL TERRESTRIAL RECEIVER
MODEM
SERIAL
AUDIO
TV
LEFT
RIGHT
VCR
COMMON INTERFACE
TV
CH 21-69
AERIAL
9
Advertisement
Table of Contents
