Advertisement
The timbres on the panel are allotted to Channels 1 through 7.
* The MULTI TIMBRE mode is off when the power is turned on.
(4)Leave the programming mode. (See p. 6)
D. LOCAL CONTROL
(1)Make sure that the piano is in the programming mode. After turning
off the MULT! TIMBRE mode, press the E. PIANO switch.
The flashing LED will change from PIANO2 to E. PIANO.
This mode is used to set whether the sound from the piano's keyboard
will be played or not, and is called the LOCAL CONTROL ON/OFF
mode. When set like this, no sound will be played when the keys are
struck.
(2)Press the highest white or black key to run LOCAL CONTROL on or
off.
White key (ON): The piano will output sound when the keys are struck.
Black key (OFF): Sound will be output only when MIDI data is received,
and not when the keyboard is played.
(3)Press the VIBRAPHONE switch to leave the programming mode.
* You can also turn this on by turning the power off and then on
again, instead of using the highest key as described above.
18
Advertisement
