Vivotek IP9165-LPC-v2 Installation Manual page 8

7.
Adjust the camera's position so that the lens module can flush align with the tempered
glass. Secure the camera using the screws and washers to the bottom of the housing.
8.
Connect 24V power source to the power input terminal. Connect power wires from the
DC 12V output to the camera. Below is the distribution board drawing power from 24V AC/
DC.
24V AC/DC OUT
24V AC/DC IN
I/O terminal block
12V DC OUT
Camera heater
Power LED
IR angle selector
Connectors to the front IR
8
Lens flush
w/ edge of
enclosure
Heater
Blower