bathstore Portfolio 630446 Assembly Instructions Manual

Portfolio Range
Base Unit Cabinet Assembly Instructions
Introduction
The following instructions will enable you to complete the assembly
of your new furniture.
Recommendation:
In fitting your furniture to avoid risk of damage we strongly
recommend that you fit all cabinets and worktops first before fitting
any door fronts
This way the doors can stay protected from any fitting tools and
dust that might scratch them.
Hardware Box
Each of the cabinets contains a
Hardware box that contains all of
the fitments you need to complete
the assembly of each unit.
So parts do not get mixed up,
please keep it safe with the unit it
came with.
Cabinet Legs
Leg Base Socket Assembly
Push the Socket of the leg boss into the pre-drilled holes on the underside of the cabinet
Then, with a firm tap of a hammer, tap the dowel to expand the socket, fixing the leg base
For additional security, if required, you can screw the legs to the base using the screws
provided.
Socket
Leg Boss
Leg Fitting & adjustment
Push the leg firmly into the base of the socket
On the threads of the adjustment foot you will find a small tab
Turning the foot so this tab is level with the end of the leg will give
you a starting leg height measurement of 150mm
Simply turn the foot to raise or lower the unit to level it as required
TIP: All units should be level to ensure tops are level and doors and
drawer fronts open and close smoothly.
Bathstore Portfolio Instructions - Issue 3.0
Basin Fascia OR
Drawer Front
Hinge Plate
Door Front
Hinges
Cabinet Legs
Note:
Fit the leg so that this
protruding
part sits underneath the
cabinet side panel
This will give improved
support to heavy worktops
Adjustment Foot
Dowel
Handles
Leg
Tab