AEG FSE74607P User Manual page 12

Use OK to enter the selected setting and to
confirm changing its value.
How to enter setting mode
You can enter setting mode before starting a
programme. You cannot enter setting mode
while the programme is running.
To enter setting mode, press and hold
simultaneously
seconds.
The lights related to the Previous, OK and
Next are on.
How to change a setting
Make sure the appliance is in setting mode.
1. Use Previous or Next to select the bar of
the ECOMETER dedicated to the desired
setting.
• The bar of the ECOMETER dedicated
to the chosen setting flashes.
• The display shows the current setting
value.
2. Press OK to enter the setting.
• The bar of the ECOMETER dedicated
to the chosen setting is on. The other
bars are off.
• The current setting value flashes.
3. Press Previous or Next to change the
value.
4. Press OK to confirm the setting.
• The new setting is saved.
• The appliance returns to the basic
settings list.
5. Press and hold simultaneously
and for about 3 seconds to exit
setting mode.
The appliance returns to the programme
selection.
The saved settings remain valid until you
change them again.
7.2 Factory reset
Factory reset restores the factory defaults.
Before the reset, make sure the appliance is
in setting mode.
12 ENGLISH
and for about 3
Press and hold Previous and Next for 5
seconds.
The displays shows _ _ _ for about 5
seconds.
The appliance returns to the programme
selection.
Factory reset does not reset the cycle
counter.
7.3 Cycle counter
You can view the number of completed
dishwashing cycles in the cycle counter.
1. Press and hold the on/off button until the
dishwasher is activated.
2. Press and hold Previous and Next for 5
seconds.
The displays shows uC and then the number
of cycles.
Press any button to exit the cycle counter.
After reaching 65535, the cycle counter
restarts.
7.4 The water softener
The water softener removes minerals from
the water supply, which would have a
negative effect on the washing results and on
the appliance.
The higher the content of these minerals, the
harder your water is. Water hardness is
measured in equivalent scales.
The water softener should be adjusted
according to the hardness of the water in your
area. Your local water authority can advise
you on the hardness of the water in your
area. Set the right level of the water softener
to assure good washing results.