Philips Saeco Map Caffitaly Bravista Espresso+ Manual page 20

ENGLISH
20
Problem
The machine does not
switch on.
The machine needs a long
time to warm up.
The pump makes a lot of
noise.
I cannot close the capsule
compartment lever
completely.
The lever does not open
completely.
The machine does not
dispense coffee or only
dispenses drops of coffee.
The machine suddenly stops
brewing coffee.
Coffee grounds end up in
the cup of coffee.
The service indicator light
lights up continuously.
The service indicator light
flashes slowly.
Why do I find water in the
waste water drawer?
Possible cause
The machine is not connected
to the mains.
The machine is clogged with
scale.
There is not enough water in
the water tank.
Water tank is not placed
correctly.
The used capsule drawer is full. Empty the used capsule drawer and
The capsule is not inserted
correctly.
The capsule is stuck.
The used capsule drawer is full. Empty the used capsule drawer.
There is not enough water in
the water tank.
Scale has built up inside the
machine.
There is not enough water in
the water tank.
A small amount of ground
coffee will always end up on
the bottom of the cup.
The machine is clogged with
scale.
The internal water circuit is
empty.
The used capsule drawer and
waste water drawer catch the
residual water released after
brewing coffee.
Solution
Put the mains plug in an earthed wall
socket.
Contact the Consumer Care Centre.
Descale the machine (see chapter
'Descaling the machine')
Fill the water tank with fresh tap water
up to the MAX indication.
Place the water tank correctly and push
it downwards.
insert the capsule again.
Insert the capsule again and check if it
is inserted correctly.
Open and close the lever a few times
with moderate force to remove the
capsule.
Fill the water tank with fresh tap water
up to the MAX indication.
Descale the machine (see chapter
'Descaling the machine').
Fill the water tank with fresh tap water
up to the MAX indication. Press the
button of selected coffee variety again
to continue brewing. When the cup is
full, press the same button again to stop
the brewing process.
This is normal.
Descale the machine (see chapter
'Descaling the machine')
Fill the water tank with fresh tap water
up to the MAX indication. Press the
lungo button to fill the internal circuit.
This is normal.