SolarEdge SE11400H Installation Manual page 28

6. Hang the inverter on the bracket: Lift the inverter from the sides, or hold it at the top and bottom of
the inverter to lift the unit into place. Do not lift holding the Safety Switch as it may be damaged.
Lower the inverter so that the notches on the inverter brackets are inserted in the holes of the wall
brackets, as shown below.
7. Optionally, secure the DC Safety Unit bracket to the wall/pole, using 1-3 screws:
NOTE
In case of inverter replacement with the DC Safety Unit still mounted, it is recommended to use all
3 holes.
a. Mark the location of the bracket screw for the Safety Switch, and optionally the two
additional bracket holes.
b. Remove the inverter from the wall/ pole.
c. Drill the hole for the Safety Switch bracket.
d. Hang the inverter on the mounted brackets.
e. Fasten the Safety Switch bracket using a standard bolt.
Single Phase Inverter with HD-Wave Technology Installation MAN-01-00306-1.1
Figure 15: Hanging the inverter on the bracket
Figure 16: Safety Switch bracket
Chapter 3: Installing the Inverter
27