Methods Of Operation; Changing The Exhaust Direction - Hitachi NR 65AK2 S Instruction And Safety Manual

English

METHODS OF OPERATION

There is a method of operation to drive nails with this
Nailer.
It is intermittent operation (Trigger fi re) only.
(1) Be sure to position and insert the fi rst nail point
through the hole in the metal connector with fi nger off
the trigger.
Be sure to position the nail with triangle mark ( ) at
noe muzzle.
Keep the tool vertically when driving.
To avoid the slipping nails, do not push the tool
forward when positioning the fi rst nail in metal hole.
Keep the tool vertically and pull backward.
(2) Pull the trigger to drive a nail with keeping your face
and hands away from the nose muzzle.
16
(3) Remove fi nger from the trigger.
(4) When charge the nail length, remove the all nails in
mark
NOTE
Metal Hole
● THIS is a SEQUENTIAL TRIP MECHANISM, and
● Always handle nails and package carefully. If nails
● After nailing:

CHANGING THE EXHAUST DIRECTION

The direction of the exhaust vent can be changed by
turning the top cover.
Remove the nailer from workpiece and reposition into
the next pre-punched metal hole.
Repeat same process.
the magazine.
WARNING
● Keep your fi nger off the trigger except during
nailing operation, because serious injury
could result if the push lever accidentally
contacts you or others in work area.
● Keep hands and body away from the
discharge area. The nail may bounce from
the recoil of driving a nail, possibly causing
injury.
should be used in accordance with all warnings and
instructions.
are dropped, collating paper may be broken.
1) disconnect air hose from the Nailer;
2) remove all nails from the Nailer;
3) supply 5 – 10 drops of Hitachi pneumatic tool
lubricant into the air plug on the Nailer; and
4) open the petcock on the air compressor tank to
drain any moisture.
WARNING
● When changing the exhaust direction, be
sure to remove your fi nger from the trigger
and disconnect the air hose from the nailer.
Top Cover
Exhaust
Vent