Abstrakt Instruments VS-1 Assembly Manual page 9

STEP 6: INSTALL PSU
https://www.youtube.com/watch?v=pcXoduPB_ns
(2) M3 x 5mm Truss Head Black Oxide Screw (orange) (Bag 1)
(1) M3 External Tooth Lock Washer (red) (Bag 2)
(2) M3 Black Oxide Washer (blue) (Bag 2)
Install SMPSU where shown. The slots in the side panel are used to mount the PSU using two M3 screws, two washers, and one
lock washer. It should be mounted so that the top of the PSU enclosure is about 16mm (5/8") below the top of the side panel. The 8
position connector should face towards the front of the VS-1. The ribbon cable clip (red) (Bag 9) will eventually be mounted on top
of the PSU enclosure - place it on top temporarily to make sure the PSU is not mounted too high. The second picture below (right-
side view) shows an exploded view to show the sequence of hardware.