Assembly Instructions; Operating Instructions; Cleaning, Care, And Maintenance - Cuisinart WAF-RP10 Series Instruction/Recipe Booklet

ASSEMBLY
INSTRUCTIONS
To insert plates
1. Place the closed unit in the horizontal
cooking position on a clean, flat surface
where you intend to use it.
2. If lid is locked, unlock and lift the lid by
grasping the handle and pushing up
in one fluid motion.
3. Insert the desired set of plates, one plate
at a time. Important: Never mix plates
from different sets.
NOTE: All plates can be used on either
the top or bottom heater.
4. Locate the two holes at the back of the
housing. Tilt the back end of the plate
and line up the pegs at the back of the
plate with the holes at the housing.
Slide the plate underneath the holes
and push down the front end of the plate.
It will snap into place.
To remove plates
1. Locate the plate-release buttons on
the right side of the waffle maker,
while the waffle maker is laying down.
Press firmly on button and the plate will
pop up slightly from the base.
2. Grasp the plate with two hands, slide it
out from the holes at the housing, and lift
it out of the base.
3. Press on the other plate-release button
to remove the second plate in the same
manner.
OPERATING
INSTRUCTIONS
1. Insert plates,
per Assembly
Instructions on
this page.
2. Plug the
power cord
into a standard
electrical outlet.
3. Adjust the temperature knob to the
desired browning setting.
NOTE: See Tips to Make Perfect Waffles
on page 6 for setting your preferred waffle
color.
4. The red indicator light will turn on to
signal that the power is on, and the waffle
maker will begin to heat. We recommend
preheating in the closed position. When
the waffle maker has reached selected
temperature, the green indicator light will
turn on and the audible tone will sound.
You are now ready to begin.
CLEANING, CARE,
AND MAINTENANCE
When you are finished cooking, unplug
the power cord from the wall outlet.
Allow the unit to cool down completely
before handling.
Press the plate-release buttons to remove
plates from the housing. Be sure that the
plates have cooled completely before
handling (at least 30 minutes). The plates
can be washed in the dishwasher. Do not
use metallic objects such as knives or forks
on the waffle plates. Do not use a scouring
pad for cleaning. The nonstick coating can
be damaged.
To clean the exterior, wipe with a soft,
dry cloth. Never use an abrasive cleanser
or harsh pad.
NEVER IMMERSE CORD, PLUG, OR UNIT
IN WATER OR OTHER LIQUIDS.
Any other servicing should be performed by
an authorized service representative.
5