Table of Contents
Advertisement
Installation
16 English
15. Attach each magnet to the inner
surface of the upper duct cover
overlapping the lower duct cover, and
assemble the upper duct cover in a
way that it fits the mounting bracket.
WARNING
Installation with screws or brackets
other than those specified in the
instruction of this manual may result in
electrical hazards.
NOTE
Magnets are included in the accessory
box.
16. Assemble with 10 mm hood fixing
screws from both sides.
17. Assemble the lower duct cover to
the hood. Magnets on the upper duct
cover hold the lower duct cover in
place.
NOTE
The magnet must be attached to the
upper line of the lower duct.
Upper
Duct
Lower
Duct
18. Remove the filter at the bottom of
the hood.
Assemble the lower duct cover by
fitting a 10 mm hood fixing screw to
the hole in the lower duct cover.
CAUTION
When removing the filter, use both
hands to avoid dropping the filter.
Advertisement
Table of Contents
