Kidde 30CUAR-V User Manual page 18

NOTE: Do not grab the shield to install or remove the alarm. Grab the alarm by the outside of the enclosure. (Figure 9-E).
NOTE: If either battery is missing, the alarm cannot mount on the mounting bracket.
• Install the alarm fully on the mounting bracket by rotating the alarm in a clockwise direction (Figure 9-F).
NOTE: The alarm will mount to the bracket in 4 positions (every 90 degrees).
• Turn on the AC power. The green AC Power On Indicator should be lit when the alarm is operating from AC power.
NOTE: Attaching AC power first, without removing the battery pull tab, will result in a false low battery
trouble condition chirp (see Troubleshooting Guide). You need to activate the batteries to eliminate
the false low battery trouble condition chirps. Remove the battery pull tab to avoid false low battery
notification.
18
Shield
Mounting Bracket
To ensure aesthetic alignment, orient
the unit as shown on the mounting
bracket and rotate the unit completely until it stops.
✘
Figure 9-E
Note orientation
of "A" line.
LED
Remove
Install
Figure 9-F
After fully installed
(The button should
be at the bottom.)