LittleGiant 6-MSP Owner's Manual

OWNER'S MANUAL
6-MSP Multi-Purpose Pump
This submersible multi-purpose pump is designed for clear water transfer applica-
tions and household water removal. The pump motor is equipped with an automatic
resetting thermal protector. Thermal Protector tripping is an indication of motor
overloading or overheating. The pump is for use with water only.
Do not use this pump for:
• Transferring potable water
• Effluent or sewage applications
• Applications where debris (gravel, sand, etc.), abrasives, or corrosives are
present
• Pumping seawater or as a pond pump
• Sprinkler systems—this pump does not deliver enough pressure for sprinkler
applications
This product is covered by a Limited Warranty for a period of 3 years from the date of original purchase by
the consumer. For complete warranty information, refer to www.LittleGiant.com.
Specifications
Model Phase
6-MSP 1
SAFETY INSTRUCTIONS
This equipment should be installed and serviced by technically qualified personnel who are familiar with
the correct selection and use of appropriate tools, equipment, and procedures. Failure to comply with
national and local electrical and plumbing codes and within Little Giant recommendations may result in
electrical shock or fire hazard, unsatisfactory performance, or equipment failure.
Know the product's application, limitations, and potential hazards. Read and follow instructions carefully to
avoid injury and property damage. Do not disassemble or repair unit unless described in this manual.
Refer to product data plate(s) for additional specifications.
Failure to follow installation or operation procedures and all applicable codes may result in the following
hazards:
Risk of death, personal injury, or property damage due to explosion,
fire, or electric shock.
• Do not use to pump flammable, combustible, or explosive fluids such as gasoline, fuel oil, kerosene, etc.
• Do not use in explosive atmospheres or hazardous locations as classified by the NEC, ANSI/NFPA70.
• Do not handle a pump or pump motor with wet hands or when standing on a wet or damp surface, or in water until the unit is
unplugged or electrically disconnected.
• When a pump is in its application, do not touch the motor, pipes, or water until the unit is unplugged or electrically disconnected.
• If the power disconnect is out of sight, lock it in the open position and tag it to prevent unexpected application of power.
Volts Hz Amps
115 60 3.5
Breaker Size Watts
10 A 350
EN
English
Shut Off
HP
(ft/m)
1/3 30 (9.1)