Related Manuals for Sorotec EHR.USBCNCV02-B
Summary of Contents for Sorotec EHR.USBCNCV02-B
- Page 1 Handwheel for EdingCNC Construction Manual EHR.USBCNCV02-B SOROTEC GmbH Tel.: +49 (0) 7227-994255-0 Withig 12 Fax: +49 (0) 7227-994255-9 77836 Rheinmünster E-Mail: sorotec@sorotec.de Version 2.0.0 Web: www.sorotec.de...
-
Page 2: Required Tools
If there are small deviations in the holes for the buttons and the rotary encoder, that‘s not a big deal. Small protrusions are covered by the com- ponents. 2 Upper part of the housing without and with attached label www.sorotec.de Page 1/6 V 2.0.0... - Page 3 7 on the next page. • Repeat the steps for the red (right) button. • Fasten the encoder with the nuts provided. 5 Button, sealing ring, retaining bracket, screw 6 Insert sealing ring into groove www.sorotec.de Page 2/6 V 2.0.0...
-
Page 4: Ground Connection
- it grey ferrule only contains plastic fibers. brown ferrule yellow ferrule • Prepare the ends of the stranded wires as shown in the table to the right. white ferrule www.sorotec.de Page 3/6 V 2.0.0... -
Page 5: Sub-D Connector
• Check all connections from the connections in the housing to the individual pins of the plug with the continuity tester (“beeper”) of a multimeter. 12 SUB-D 9 pin numbers. The soldering side is shown. www.sorotec.de Page 4/6 V 2.0.0... - Page 6 • Assemble the upper part of the connector housing with the included screws and nuts (see picture 15). 13 Strain relief on shrink tubing, housing half 14 Locking screw with retaining plate 15 Plug fully assembled 16 Circuit diagram www.sorotec.de Page 5/6 V 2.0.0...
-
Page 7: Final Assembly
You can also find the operating instruc- • Bring the top and bottom parts of the case tions for download on the Sorotec shop website. together. Pay careful attention to the position of the sealing lip of the impact protection. This process can be difficult, please be patient.
Need help?
Do you have a question about the EHR.USBCNCV02-B and is the answer not in the manual?
Questions and answers