Table of Contents
Advertisement
Loosen and tighten the M5 x 35 screws to align the
appliance.
Tighten the screws for the appliance bracket.
5.
Secure the appliance.
6.
3
3
3,9 x 22
3
Remove the protective film from the grease filters.
7.
Fit the grease filters.
8.
To avoid causing damage, do not bend the grease
filters.
Establishing the exhaust air connection
Screw the air outlet onto the housing.
1.
If required, fit the flue adapter onto the air outlet and
2.
press firmly.
Secure the exhaust pipe to the air pipe connector.
3.
Establish the connection to the exhaust air opening.
4.
Seal the joints.
5.
Establishing the power supply
Note: Only licensed specialists may connect the appli-
ance. Damage caused by incorrect connection is not
covered under the warranty.
In accordance with safety regulations, an all-pole separ-
ator with at least a 3 mm contact opening must be
provided.
Identify the phase and neutral conductors in the
1.
socket.
The appliance may be damaged if it is not connec-
ted correctly.
Only connect the appliance to a mains voltage
2.
between 220 und 240 V.
Connect the wires of the mains power cable accord-
3.
ing to the colour coding:
Blue = Neutral conductor
‒
Brown = Phase (external conductor)
‒
Fitting the flue duct
WARNING ‒ Risk of injury!
Components inside the appliance may have sharp
edges.
Wear protective gloves.
▶
Remove the protective foil from both flue duct sec-
1.
tions.
Fit the inner and outer flue within each other.
2.
Screw the inner flue onto both sides of the flue con-
3.
nection plate.
Removing the appliance
Disconnect the appliance from the power supply.
1.
Remove the flue duct.
2.
Loosen the exhaust pipe.
3.
Remove the grease filters.
4.
To avoid causing damage, do not bend the grease
filters.
Loosen the screws for the appliance bracket slightly
5.
but do not undo them fully.
6.
Remove the appliance.
Remove the flue connection plate.
7.
Installation instructions en
15
Advertisement
Table of Contents
