Table of Contents
Advertisement
• Cut off the pipe exist from inside of Front panel using a coping saw or an
equivalent tool.
• The plastic burrs from the cutting process should be removed with a half
round fi le or an equivalent tool.
Coping saw
How to cutting the air inlet grille
• To connect piping to the left or right side, the air inlet grille must be cut off.
• The marking for cutting are indicated on the inside of the air inlet grille in
the following positions.
Pre-cut mark is inside
Left
• Cut off the pipe exist from inside of the Air inlet grille using a coping saw
or an equivalent tool.
• The plastic burrs from the cutting process should be removed with a half
round fi le or an equivalent tool.
CAUTION
When cutting the Front panel and the Air inlet grille, be careful of cutting
tools and any sharp edges of plastic. It can cause injuries.
How to remove the drain hose
• Removed fi xing screw of LED set then pull out it from the main body.
• Removed 2 screws to fi x drain pan then secure remove the drain pan from
the main body.
Drain pan
Screw 2 pcs.
• The drain hose can be removed by removing the screw securing the drain
hose then secure rotate steel plate of drain hose to out of the Drain pan
and pulling out the drain hose.
Steel plate
of drain hose
Half round fi le
Pre-cut mark is inside
Front
LED set
Screw
Screwdriver
Screw
Drain hose
How to fi x the drain hose
• To install the drain hose, insert the drain hose fi rmly until the connection
part contacts with heat insulator, secure push steel plate of drain hose to
predetermined position of Drain pan then fi x it by original screw.
Drain pan
CAUTION
When removing or install the drain hose, be careful of any sharp edges
of steel plate. The edges can cause injuries.
How to remove the drain cap
• Clip the drain cap by needle-nose pliers and pull out.
Right
How to fi x the drain cap
• Insert hexagonal wrench (dia. 4 mm) in a center head.
• Firmly insert the drain cap.
Do not apply lubricating oil
(refrigerant machine oil)
when inserting the drain
cap. Application causes
deterioration and drain
leakage from the plug.
CAUTION
Firmly insert the drain hose and drain cap; otherwise, water may leak.
9
Screw
Drain hose
Cap drain
Needle-nose pliers
Hexagonal wrench
No gap
Heat insulator (foam)
Insert a hexagon wrench
(4 mm).
Advertisement
Table of Contents
