Drainage - Toshiba RAS-B10S4KVPG-E Installation Manual

How to remove the air inlet grille
1. Be careful open the air inlet grille until arm touch the stopper of the front
panel.
2. Push arms on left and right side to outward direction then pull toward you
to remove front panel.
Front panel
Arm of the
air inlet grille
Push arm to outward direction
Air inlet grille
Front panel
How to install the air inlet grille
1. Fit the left and right arms of the air inlet grille to the slot holes on the two
sides of the front panel and push in completely.
2. Close the air inlet grille.
Be sure to press the positions as indicated by the arrow in order to attach
the air inlet grille to the indoor unit.
CAUTION
The air inlet grille should be removed before installing the indoor unit.
To avoid damage to the corner of the air inlet grille or the wall.
1. Run the drain hose sloped downwards.
NOTE
• The hole should be made at a slight downward slant on the outdoor side.
Do not rise the
drain hose.
50 mm
or more
2. Put water in the drain pan and make sure that the water is drained out of
doors.
3. When connecting extension drain hose, insulate the connecting part of
extension drain hose with shield pipe.
Drain hose
CAUTION
Arrange the drain pipe for proper drainage from the unit.
Improper drainage can result in dew-dropping.
This air conditioner has the structure designed
to drain water collected from dew, which forms
on the back of the indoor unit, to the drain pan.
Therefore, do not store the power cord and other
parts at a height above the drain guide.
11

Drainage

Do not form the
drain hose into
a wavy shape.
Do not put the
drain hose end
into water.
Shield pipe
Extension drain hose
Inside the room
Space for pipes
Do not put the
drain hose end in
the drainage ditch.
Wall
Drain
guide