ZyXEL Communications PLA-402 V2 Quick Start Manual page 7

3 Press the ENCRYPT buttons at the rear of your powerline devices for 1~2 seconds
B
4 While the devices are connecting, the power (
several times all lights blink at the same time and the HomePlug (
5 Wait for about one minute while your powerline devices connect. The power (
steady when the ENCRYPT process times out, the HomePlug (
have a successful connection.
If the power (
ENCRYPT button for too long. Try again, pressing the ENCRYPT button for
1~2 seconds.
If the HomePlug (
powerline devices are not connected. Repeat steps 2 and 3 in this
section. If that doesn't work, see the User's Guide for more suggestions.
A
PRESS
10~15 SEC.
PRESS
2 SEC.
) light does not blink, you have probably pressed the
) lights on both powerline devices do not light up, the
ENGLISH
WITHIN
120 SEC.
) and HomePlug (
7
C
PRESS
2 SEC.
) lights blink. Also
) light shows red.
) light is steady if you
) light is