Table of Contents
Advertisement
LAUNCH
Study, understand and follow all instructions provided with this product. Read these instructions
carefully before installing, operating, servicing or repairing this tool. Keep these instructions in a safe,
accessible place.
Caution: To help prevent personal injury, follow the instructions below.
Handle device carefully. Do not drop, bend, puncture, insert foreign objects, or place heavy
objects on the device. The fragile components inside the unit may be damaged.
Connect and disconnect properly. Do not connect or disconnect probes or test leads while
they are connected to a voltage source.
Observe all terminal ratings. To avoid fire or shock hazard, observe all ratings and markings
on the product. Consult the product manual for further ratings information before making
connections to the product.
Use proper probe. To avoid shock hazard, use a properly rated probe for your measurement.
Avoid circuit or wire exposure. Do not touch exposed connections and components when
power is on.
Do not operate if the unit is, or suspected to be damaged. If suspected damage occurs with
the device, have it inspected by qualified service personnel before further operations.
Do not operate in wet/damp conditions.
Do not operate in an explosive atmosphere.
Keep product surfaces clean and dry.
Do not disassemble or refit the device. The device is a sealed device and there are no
end-user serviceable parts inside. All internal repairs must be carried out by authorized
maintenance agencies or authorized technicians. Attempts to disassemble or refit the device will
void the warranty.
Do not try to replace the internal battery. The internal rechargeable battery must be replaced
by authorized maintenance agencies or authorized technicians.
Any Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy, and if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
EM101N New Energy Oscillograph Multimeter User Manual
WARNING
FCC STATEMENT
i
Advertisement
Table of Contents
