NEC N8103-120 User Manual page 73

51
11.
Connect the cable between the RAID controller and the system to recover original
state
12.
Put Setup Date Label to the place that you notice easily such as system case.
13.
Install the side cover on the server. Connect power cord to the receptacles to
recover the original state and power on the system.
14.
To confirm whether the RAID controller is recognized from system after OS
started. In detail, refer to [2-2. Checking by Utility].
・Universal RAID Utility may not able to recognize the battery pack if it is charged
only at the minimum level (or uncharged). If this occurs, charge the battery pack
for 24 hours or more. Then reboot the server and try to recognize the battery pack
again by using Universal RAID Utility.
Notice
・There is a case that a refreshment function works when you use new battery.
When refreshment works, the battery works as White Through. In this case,
confirm a state of the battery about 9 hours later.
The battery pack is recyclable. To inquire about it , contact your service
representative or bring it to the nearest recycle agent.
Tips
SAS Cable
Connector
(Port0~3)
RAID Controller
RAID Battery Backup
Unit
(N8103-120)