Advertisement
Installing the Stand or Wall Mount Bracket
CAUTION
Be sure to disconnect the AC power cord before removing a base stand or installing
wall mount brackets.
The display on your TV is fragile. Make sure the TV screen is not scratched or
damaged by hard objects or from pressure.
After the installation is complete, make sure the TV is steady on a table or firmly
attached to a wall mount, before removing all protective film, if any.
Installing the stand
Follow the illustrations and textual instructions below to complete the installation steps:
For 43"
1. Carefully place your TV facedown on
a soft, flat surface to prevent damage
to the TV or scratching to the screen.
2. Ta k e o u t t h e 2 s t a n d s f r o m t h e
accessory bag and then insert the
stands into the bottom slots of the TV.
3. Secure the Base Stand to the TV with
the 4 screws in the accessory bag
tightly.
For 85"
ATTENTION
Follow the illustrations and textual instructions below to complete the stand installation steps.
Two people and above are required.
1. First follow the instructions on the
carbon box. Open the box, take out
the base stands and then take out
the upper cushion, left cushion and
right cushion. Make sure the side of
left and right cushion is aligned with
the gap of upper cushion(to avoid the
interference between cushions and
the base stand when installing it), just
as the picture shows below.
2. Two people stand on each side of the
television. Hold the back side of TV
with one hand and grasp the buckle
on lower box with the other hand.
Place the TV on the cushions with the
screen face upward. Make the handle
touch upper cushion, back cover touch
the left and right cushions. When
finished, take off the lower box.
Screws:
Base Stand
M4×16
align
left and right cushion
screen face upward
left and
right
cushion
1
Base Stand
upper cushion
700-800mm
about 50 mm
align
handle
upper
cushion
Advertisement
