Advertisement
Installing Batteries in the Remote Control
1.
Slide the back cover to open the battery compartment of the remote control.
Insert two AA or AAA size batteries. Make sure to match the (+) and ( - ) ends of the
2.
batteries with the (+) and ( - ) ends indicated in the battery compartment.
Close the battery compartment with the cover.
3.
NOTE
Product image is only for reference, actual product may vary in appearance.
Dispose of your batteries in a designated disposal area.
Do not mix battery types or combine used batteries with new ones.
Remove depleted batteries immediately to prevent battery acid from leaking into the battery
compartment.
If you do not intend to use the remote control for a long time, remove the batteries.
Leaving a battery in an extremely high temperature surrounding environment that can result in
an explosion or the leakage of flammable liquid or gas.
Battery chemicals can cause a rash. If the batteries leak, clean the battery compartment with a
cloth. If chemicals touch your skin, wash immediately.
Risk of fire or explosion if the battery is replaced by an incorrect type.
Disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, that
can result in an explosion.
A battery subjected to extremely low air pressure that may result in an explosion or the leakage
of flammable liquid or gas.
Pairing the Remote Control (only for Bluetooth remote control)
Pair the remote to the TV after you power it on. Keep the remote control within 3
metres from the TV. Press any button (except power and mic button) to pair.
NOTE
In special cases, press and hold [
If an unknown error occurred with the remote, then it could have been caused by
interference. Try to remove what's causing the interference and pair it again.
If an unknown error occurred in the remote control while the battery power is normal,
you can take out the batteries, press any key for 1~2 seconds, and insert them
back. Then the remote control will work normally.
The remote cannot be paired to the TV while the TV is in standby mode.
Remote Control Operation Range
1. The remote control can work at a distance of up to 8 meters in front of the TV set.
2. The remote control angle: taking the remote sensor as an apex, 6 meters away, its
controlled horizontal angle is within ±30°, while the vertical angle is within ±15°.
3. The operating distance may vary depending on the brightness of the room.
43"
30°
30°
6m
6m
8m
] button to pair.
85"
30°
30°
6m
6m
8m
8
Disposal of this unit
Product should not be
damaged, dismantled
or thrown in municipal
waste.
It should be packed and
handed over to autho-
rised re-cycler.
Advertisement
