Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
^^^Remove the log splitter, parts pack all all literature
:rom the crate before discarding crate.
2. Block up rear end of log splitter so that the rear
wheels may be assembled.
3. Place flat washers (A) on axle, then wheels and
secure with collars and set screws (B). See figures
1 and 2.
4. The engagement handle is partly assembled, pivot
handle upward intopositionand secure with shoulder
bolt (C). See figure 3.
FIGURE 1
ENGAGEMENT HANDLE
SHOULDER BOLT (C)
SHOULDER BOLT
ALREADY IN
COLLAR
8
?
SET SCRE'
WHEEL
FIGURE 3
5. Tighten both shoulder bolts securely.
OPERATION
1. Service engine with gas and oil. See engine manual
packed with log splitter for complete instructions
for the care and maintenance of engine. READ
DIRECTIONS CAREFULLY.
CAUTION
You
must
not
operate
log splitter
without proper amount of oil in reser¬
voir tank.
FIGURE 2
2. Remove the breather cap from reservoir tank.
3
See figure 4.
Advertisement
Table of Contents
