U-Line H-11312 Quick Start Manual
U-Line H-11312 Quick Start Manual

U-Line H-11312 Quick Start Manual

Led wet location emergency light

Advertisement

Available languages

Available languages

H-11312
LED WET LOCATION
EMERGENCY LIGHT
TOOLS NEEDED
Phillips
Flathead
Screwdriver
Screwdriver
CAUTION! When using electrical equipment,
always follow basic safety precautions, including:
• Disconnect power at fuse or circuit breaker
before installing or servicing.
• Do not mount in hazardous locations or near
gas or electric heaters.
• Do not let power cords touch a hot surface.
• Equipment should be mounted in locations
and at heights where it will not be subjected
to tampering by unauthorized personnel.
• The use of accessory equipment not
recommended by the manufacturer. May
cause an unsafe condition.
MOUNTING
1.
Remove clear cover. (See Figure 1)
Figure 1
PAGE 1 OF 6
1-800-295-5510
uline.com
SAFETY
INSTALLATION
2. Insert flathead screwdriver into two slots to pry off
Pour le français, consulter les pages 5-6.
• Do not use this equipment for anything other
than intended use.
• All servicing should be performed by
qualified personnel only.
• Allow battery to charge for 24 hours before
first use.
NOTE: Replace the batteries as needed
according to ambient conditions. It is
recommended that equipment be tested
regularly in accordance with local codes.
front cover from back plate. (See Figure 2)
Figure 2
Para Español, vea páginas 3-4.
Slots
1223 IH-11312

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the H-11312 and is the answer not in the manual?

Questions and answers

Summary of Contents for U-Line H-11312

  • Page 1 Para Español, vea páginas 3-4. Pour le français, consulter les pages 5-6. H-11312 1-800-295-5510 uline.com LED WET LOCATION EMERGENCY LIGHT TOOLS NEEDED Phillips Flathead Screwdriver Screwdriver SAFETY CAUTION! When using electrical equipment, • Do not use this equipment for anything other always follow basic safety precautions, including: than intended use.
  • Page 2 INSTALLATION CONTINUED 3. Remove the back plate. (See Figure 3) 6. Shut off power. Connect unit to single AC power source. (See Figures 7-8) Figure 3 NOTE: If using 120 VAC, connect black and white leads to building utility. NOTE: If using 277 VAC, connect orange and white leads to building utility.
  • Page 3: Herramientas Necesarias

    H-11312 800-295-5510 uline.mx LÁMPARA LED DE EMERGENCIA PARA ÁREAS MOJADAS HERRAMIENTAS NECESARIAS Desarmador Desarmador de Cruz Plano SEGURIDAD ¡PRECAUCIÓN! Cuando utilice equipos • El uso de cualquier equipo complementario eléctricos, siga siempre las precauciones de no recomendado por el fabricante podría seguridad básicas, que incluyen:...
  • Page 4 CONTINUACIÓN DE INSTALACIÓN 3. Retire la placa posterior. (Vea Diagrama 3) 6. Apague la corriente. Conecte la unidad a una fuente única de energía CA. (Vea Diagramas 7-8) Diagrama 3 NOTA: Si usa 120 VAC, conecte las puntas negras y blancas a la corriente del edificio. NOTA: Si usa 277 VAC, conecte las puntas Placa naranjas y blancas a la corriente del edificio.
  • Page 5: Outils Requis

    H-11312 1-800-295-5510 uline.ca LUMIÈRE DE SECOURS DEL POUR ENVIRONNEMENT HUMIDE OUTILS REQUIS Tournevis Tournevis à tête cruciforme plate SÉCURITÉ MISE EN GARDE! Lors de l'utilisation d'appareils • L'utilisation d'accessoires non recommandés électriques, vous devez toujours respecter par le fabricant peut entraîner des situations les règles de sécurité...
  • Page 6 INSTALLATION SUITE 3. Retirez la plaque arrière. (Voir Figure 3) 6. Coupez l'alimentation. Branchez l'appareil dans une source d'alimentation CA. (Voir Figures 7 et 8) Figure 3 REMARQUE : Si vous utilisez du courant à 120 VCA, branchez les fils noir et blanc au réseau électrique.

Table of Contents