Cleaning; Safety Inspection; Disposal - ebm-papst G2E140-AB17-50 Operating Instructions Manual

Hide thumbs

Table of Contents

G2E140-AB17-50

Motor

Ambient temperature

overtemperature

too high

Deficient cooling

In the event of further malfunctions, contact ebm-papst.

5.1 Cleaning

To ensure a long service life, check the fans regularly for proper

operation and soiling. The frequency of checking is to be adapted

accordingly depending on the degree of soiling.

DANGER

Risk of injury from rotating fan.

→ Only clean when not in motion. Interrupt the power supply,

secure against renewed switch-on. Secure against start-up,

prevent air flow.

; Dirt deposits on the motor housing can cause overheating of the motor.

; Soiling of the impeller can cause vibration that will shorten the service

life of the fan.

; Severe vibration can destroy the fan.

; In such cases, switch off the fan immediately and clean it.

; The preferred method of cleaning is dry cleaning, e.g. using

compressed air.

; If water is required for cleaning, the preferred method is to perform

cleaning with a conventional water hose or to employ foam cleaning.

; Do not use aggressive cleaning agents!

NOTE

Damage to the device during cleaning

Malfunction possible

→ Do not clean the device using a water jet or high-pressure

cleaner.

→ Do not use any acid, alkali or solvent-basedcleaning

agents.

→ Do not use any pointed or sharp-edged objects for cleaning

; If cleaning agents have been used, rinse these off with clean water.

; If severe corrosion is visible on load-bearing or rotating parts, switch

off the device immediately and replace it.

; Repair of load-bearing or rotating parts is not permitted.

; Operate the fan for 2 hours at maximum speed to permit the

evaporation of any water that has ingressed.

; If cleaning does not eliminate vibrations, the fan may need to be

rebalanced. To have it rebalanced, contact ebm-papst.

; The fan is equipped with maintenance-free ball bearings. The lifetime

lubrication of the ball bearings is designed for a service life of 40,000

hours.

; If bearing replacement is necessary after that period, contact ebm-

papst.

; Adapt the maintenance intervals to the level of dust exposure.

Item no. 15132-5-9970 · ENU · Change 202174 · Approved 2018-12-28 · Page 10 / 11

ebm-papst Mulfingen GmbH & Co. KG · Bachmühle 2 · D-74673 Mulfingen · Phone +49 (0) 7938 81-0 · Fax +49 (0) 7938 81-110 · info1@de.ebmpapst.com · www.ebmpapst.com

Operating instructions

Reduce ambient

5.2 Safety inspection

temperature if possible

What to check

Improve cooling

Contact

protection

cover for

intactness or

damage

Device for

damage to

blades and

housing

Fastening the

cables

Fastening the

protective earth

terminal

Insulation of

cables for

damage

Abnormal

bearing noise

5.3 Disposal

For ebm-papst, environmental protection and resource preservation are

top priority corporate goals.

ebm-papst operates an environmental management system which is

certified in accordance with ISO 14001 and rigorously implemented

around the world on the basis of German standards.

Right from the development stage, ecological design, technical safety

and health protection are fixed criteria.

The following section contains recommendations for ecological disposal

of the product and its components.

5.3.1 Country-specific legal requirements

5.3.2 Disassembly

Disassembly of the product must be performed or supervised by

qualified personnel with the appropriate technical knowledge.

The product is to be disassembled into suitable components for disposal

employing standard procedures for motors.

How to check

How often