Wan Mac Address - ZyXEL Communications NBG-318S Quick Start Manual

3.5 WAN MAC Address

1 Configure the WAN port's MAC address by either using the factory assigned default
MAC address or cloning the MAC address of a computer on your LAN. By default, the
NBG-318S uses the factory assigned MAC address to identify itself on the WAN.
• Select Factory Default to use the factory-assigned, default MAC address.
• Select Clone the Computer's MAC Address to clone the MAC address from a computer
on your LAN. Type the IP address of the computer with the MAC address you are cloning. It
is advisable to clone the MAC address from a computer on your LAN even if your ISP does
not presently require MAC address authentication.
• Select Set WAN MAC Address and enter the MAC address you want to use.
2 Select Enable BM for all traffic automatically to have the NBG-318S apply bandwidth
management to traffic going out through any interface according to the traffic type.
Click Next.
3 Click Apply to save your changes in the next screen that appears in the wizard.
If you have any Internet access problems, follow the on-screen instructions.
4 Click Finish in the screen below to complete the wizard setup.
5 Congratulations. Open a web browser, such as Internet Explorer, to visit your favorite
website.
4 Wireless Network Setup
Set up a wireless network with at least one other computer with a wireless network card/
adapter. To add a computer to your network, you need to configure your wireless-enabled
computer with the same SSID, channel and security settings as the NBG-318S. See the
note from section 3.
ENGLISH
9