Advertisement
CONNECTION
• Input sensitivity control
The input sensitivity can be adjusted to 0.3 or 5 V
through a system to be connected to this switch.
If you are going to connect a KENWOOD system
to this switch, then, normally use this switch as
it is (0.3 V).
_
• As the unit uses BTL output, always connect the without stripe speaker
wires to the © terminals of the speaker systems. Never let the ©
speaker wires touch and never connect them to the chassis (ground).
Do not let the speaker terminals come into contact with the chassis
(ground).
insulate any unused output wire to prevent a short circuit.
* Secure unconnected wires properly so that they do not contact the
vehicle chassis.
10
iEn>
Advertisement
