Connection - Kenwood KOS-V1000 Instruction Manual

Connection

Antenna cord is used when
receiving a radio station with
the built-in tuner.
In this case, set "TUNER
source" in <System Setup>
(page 60) to "On".
Ignition key
switch
Car fuse box
Car fuse box
(Main fuse)
+ –
Battery
Connect to the terminal that is grounded when either
connect either to the control terminal of the motor antenna, or to the
power terminal for the booster amplifier of the film-type antenna.
84 KOS-V1000
FM/AM antenna input
ACC
A
B
B
C
C
Connect to the vehicle's parking brake
detection switch harness
using the supplied relay connector.
Parking sensor wire (Light Green)
PRK SW
For the sake of safety, be sure to connect the parking sensor.
To vehicle's reverse lamp harness
To car light control switch
the telephone rings or during conversation.
Depending on what antenna you are using,
When using the optional power amplifier,
connect to its power control terminal.
To "EXT.AMP.CONT. " terminal of the amplifier
having the external amp control function.
If no connections are made, do not let the cable come out from the tab.
Accessory 4
FUSE ( 5A )
Battery wire (Yellow)
Ground wire (Black) - (To car chassis)
B
A
C
Reverse sensor wire (Purple/White)
Dimmer control wire (Orange/White)
Steering remote control input (Light Blue/Yellow)
To steering remote
Mute wire (Brown)
Motor antenna control wire (Blue)
Power control wire (Blue/White)
External amplifier control wire (Pink/Black)
Antenna Cord
Wiring harness
(Accessory 2)
FUSE ( 15A )
Battery wire (Yellow)
Ignition wire (Red)
Ground wire (Black) - (To car chassis)