Table of Contents
Advertisement
8
Before you can stream music from your mobile device (iOS device or Android device) to this sound system
through Bluetooth, pair the sound system with your mobile device.
Bluetooth LED indicator
1.
Make sure the AUX cable is not connected to the sound system. Press and hold
controller to turn on the unit.
The Bluetooth LED indicator on the functional controller flashes blue. This indicates that the sound system
enters Bluetooth pairing mode.
2.
On your mobile device, enable Bluetooth function and select the device name ("Planet Audio ATV") to pair the
sound system with the mobile device. If prompted for password, input "0000".
Note: Only one device can be paired at a time.
3.
When successfully paired/connected, The Bluetooth LED indicator turns to solid blue from flash.
Play audio on your mobile device, and audio will be streamed to the sound system. Use the volume control
on the connected device to adjust volume.
After pairing, the sound system will automatically connect to your mobile device each time the two are both
turned on. To change Bluetooth source, disconnect the current Bluetooth connection then repeat the steps
above to connect/pair with another mobile device.
To maximize audio performance, set the volume of the connected device to a minimum of 75%.
Ideally, on the highest volume setting you can get without distortion.
To avoid battery exhaustion, be sure to run the vehicle engine when operating the sound system.
Operational range can be reduced by any obstacle between the sound system and the device.
If the connected device is out of the effective range from the sound system, the device will be
automatically disconnected. The device will be automatically re-connected if it is back to the range.
Playback control
1
• To pause or resume play, press
• To select the previous or next track, press
• To adjust volume, press / .
Bluetooth
.
or
.
on the functional
Advertisement
Table of Contents
