Chevrolet Camaro 2024 Owner's Manual page 40

Hood Extractor
Caution
Using wax on low gloss black finish
stripes can increase the gloss level and
create a non-uniform finish. Clean low
gloss stripes with soap and water only.
It is not recommended that the ZL1 hood
extractor be waxed, as it will change the
gloss level of the surface. In addition, care
must be used when waxing around the
hood extractor. If a small amount of wax is
applied to the hood extractor it can create
an irregular appearance in the surface of the
panel. If wax, debris, or other materials
create stains on the hood extractor, see
your dealer for the recommended cleaner.
There is a water deflector on the underside
of the hood extractor. Remove it for track
use only.
Hood Wrap (1LE Only)
Caring for Vehicle Graphics
Wash regularly.
Wash whenever the car appears dirty.
Contaminants allowed to remain on the
graphic may be more difficult to remove
during cleaning.
Rinse off as much dirt and grit as possible
with a spray of water.
Vehicle Care
Never scrub the hood wrap surface.
Use a wet, non-abrasive detergent.
Do not buff or apply polishes to the
hood wrap.
Rinse thoroughly with clean water. To
reduce water spotting, immediately use a
silicone squeegee to remove water. Finish
with a clean microfiber cloth.
Pressure Washing
Ensure the water pressure is kept below
14,000 kPa (2,000 psi).
Keep water temperature below 80 °C (180
°F).
Use a spray nozzle with a 40 degree wide
angle spray pattern.
Keep the nozzle at least 30 cm (1 ft) away
from and perpendicular (at 90 degrees) to
any graphics.
Cleaning Underhood Components
Caution
Do not power wash any component
under the hood that has this
symbol.
This could cause damage that would not
be covered by the vehicle warranty.
39