Table of Contents
Advertisement
Adjustable Rear Stabilizer Bar
(ZL1 1LE Only)
The rear stabilizer bar ends have three
attachment positions that allow the rear roll
stiffness of the vehicle to be adjusted.
The stabilizer bar stiffness increases
approximately 15% using the rearward holes,
or decreases approximately 10% using the
forward holes.
To change the attachment position:
1. Raise and support the rear of the vehicle.
2. Remove the stabilizer bar link nut while
holding the ball stud end.
3. Reposition the stabilizer bar link stud to
the desired hole and tighten to 43
(32 lb ft). Use the same hole position for
both sides of the vehicle.
Driving and Operating
Wheel Alignment
Track alignment specifications are for vehicle
at curb weight conditions (full tank of fuel,
zero ballast).
Racing and competitive driving wheel
alignment settings can be set as follows for
increased handling performance:
19
Advertisement
Chapters
Table of Contents
