Table of Contents
Advertisement
3.3 Network connection trouble-shooting
If the connection cannot be established please follow these steps:
1.
Is the power cable with mains adaptor plugged-in and is the camera powered-
up? If so, the fans turn which creates a distinctive noise (even with closed
waterproof case).
2.
Do you know the IP of your camera? The standard (factory) IP is 192.168.1.80.
3.
Have you set the correct IP on your computer? The computer IP needs to be
different from the camera IP but in the same range, for example:
camera: 192.168.1.80
computer IP: 192.168.1.70
subnet mask: 255.255.255.0
gateway: 192.168.1.1
4.
If all fails, please reset the camera IP either to a fixed (factory) IP or to DHCP:
DHCP
fixed IP (192.168.1.80)
Reboot the computer by turning the power off/on.
Wait approximately 5 minutes for the camera to reinitialise.
It may be necessary to repeat this procedure.
Installation Manual Roundshot Livecam Generation 4 - April 2024 - © by Seitz Phototechnik AG / Switzerland
Push button to set camera
computer network IP to ...
To indicate the current IP setting, a
green LED lights up permanently
www.roundshot.com
page 30
Advertisement
Table of Contents
