3. Camera installation
3.1 Network connection with DSL / wired
Please test the network connection in the office before installing the Livecam on
the mast. This avoids lengthy installations/deinstallations.
Before shipping the Roundshot team will prepare the network card of the Livecam
computer according to customer instructions:
•
DHCP (to assign automatically by switch/router/network (standard case for private
or small networks)
•
Fixed IP (for larger networks where IPs are assigned by network administrator)
In this case the Livecam should connect to internet automatically once installed.
Please allow 5-10 minutes for the camera to power up, calibrate itself and obtain the IP
or register in the network. Once the internet connection is established, the Livecam
will automatically log in at the Roundshot VPN server and the Roundshot staff can
connect to the camera.
Mains adaptor
110-220V / 24V
mains
adaptor
Contact the Roundshot team who will check if the connection to the VPN (remote
access to camera) has been successfully established.
If yes, we will now connect to the camera to configure it for service.
If no, please go to section «problem solving» to establish the connection.
Installation Manual Roundshot Livecam Generation 4 - April 2024 - © by Seitz Phototechnik AG / Switzerland
IP:
DHCP or
•
Fixed
•
Ethernet
cable (RJ45)
Internet access
www
Switch
Router / DSL
www.roundshot.com
Roundshot
VPN server
page 19