Yamaha EMT-1 User Manual page 8

Hi SLOW/FAST (Attack) Variation
The large SLOW and FAST buttons located to the right of the panel can
be used to modify the attack of the selected voice—i.e. whether the notes
begin sharply or smoothly—in 5 step:
SLOWEST 4 SLOW < NORMAL > FAST b FASTEST
Varying Pitch
When the POWER switch is initially turned ON, the EMT-1 is set to standard pitch:
A3=440 Hz. The PITCH buttons can be used to '"'tune'' the EMT-1 to match the pitch
of other instruments. Each time you press the PITCH P or < button, the pitch is
direction. The maximum amount of pitch variation is +50 cents, allowing you to tune
the EMT-1 over approximately a semitone range. Standard pitch can be restored by
pressing both the 4 and > PITCH buttons simultaneously.
Using the Split Mode
Normally, any voice you select can be played over the entire range of the controlling keyboard you use. The EMT-1 SPLIT
mode, however, allows you to play a bass voice on the left side of the keyboard and any other voice on the right-hand
section.
To activate the SPLIT mode, hold down one of the bass voice selectors (marked with the ''—BASS—"' label), and, while
holding the bass voice selector, select any other non-bass voice in the normal way. The selected bass voice can now be played
on the lower (left-hand) section of the keyboard and the second ''lead'' voice selected can be played on the upper (right-hand)
section. The LED indicators will show the selected ''lead'' voice.
The SPLIT mode can be exited by selecting any voice in the normal way.
Fre
© | VIBES_ MARIMBA CLAVI
O [GUITAR 1 GUITAR 2 GUITAR 3 SITAR ELEC. SIAP SYNTH
L Bass} ——
1 i !
1 i t
C ere ee |
Bass Voice