Advertisement
Available languages
Available languages
INSTALLING TABLE TOP INSERTS IN THE MOUNTING PLATE
TABLE TOP INSERTS (FIG. 25)
This router table includes three table top inserts with
the following hole sizes:
• 1" in diameter, for use with bits with diameters up
to 7/8" (16).
• 2" in diameter, for use with bits with diameters up
to 1-7/8" (17).
• 2-3/4" in diameter, for use with bits with diameters up
to 2-5/8" (18).
The adapter plate has a 3-5/8" hole for use with bits
with diameters of up to 3-1/2". No insert is used for bits
with diameters over 2-5/8".
Do not use the router table with
bits over 3-1/2" in diameter. A 3-1/2" diameter bit is
the largest bit that can be used with the router table!
MAKE SURE THE ROUTER IS TURNED OFF AND/OR
UNPLUGGED BEFORE PROCEEDING!
TO INSTALL TABLE TOP INSERTS (FIG. 26):
1.
Select the table top insert that best accommodates
the router bit to be used.
2.
Press the insert into the large hole in the router
adapter plate. If the fence is in the way, loosen the
clamping knobs on the fence support brackets and
slide the fence back out of the way.
3.
Press down evenly over the tabs until the insert
locks into place.
4.
To remove, first remove the router bit from the
router. Then insert a finger into the hole in the
table top insert and pull up gently until the tabs
disengage. When not in use, store table top inserts
in the storage panel.
Router Table Assembly
FIG. 25
FIG. 26
23
2-3/4" HOLE
2" HOLE
1" HOLE
3-5/8" HOLE IN ROUTER
MOUNTING PLATE
Advertisement
